24" Hardwired Power Strip with 6 Outlets
Warning: Last items in stock!
By buying this product you can collect up to 2 loyalty points. Your cart will total 2 points that can be converted into a voucher of $0.40.
EPS-H206NVG 24" Hardwired Power Strip with 6 Outlets
This hardwired type power strip is good for installation in your kitchen, garage for cabinet, rack, island, countertop and so on. It is not for normal wall outlets. There is no power cord and plug with this unit.
Model #: EPS-H206NVG Description: 24" 6 Outlet Hardwired Power Strip, Beige Power Strip Measurement: L24" x W1.614" x H1.255" (609 x 42 x 32mm) * Outlets: 6 Outlet Color: Black Outlet Orientation: Vertical Receptacle Type: NEMA 5-15R Outlet Spacing: 3-1/8" (79mm) (center to center) Cord Exit Knockout 6 (on top and bottom cover, both sides and ends) Voltage Input/Output: 110-125V 60Hz Current Input: 15A Full Load: 1875VA (Recommended Max Load 1440W) On/Off Switch: N/A Circuit Breaker: N/A Surge Protection: N/A Indicators: N/A Mounting Tabs: N/A Mounting Clips: 3/4" (19mm) Spring steel clips included
Installation work of this unit must be done by a professional, a licensed electrician or an electric engineer.
Never install this unit during a thunder storm.
Switch off the power before you start installation work.
This unit is for indoor use only.
This unit is not intended for use in or around wet or potentially wet areas including, but not limited to, aquariums, saunas, showers and fountains.
Risk of Electric Shock!
Before installation, you may need to get a 3/8" wire clamp connector (also known as Romex Connector) and 3 wire connectors (also referred to as terminal connectors. Decide your wire gauge, and ask store attendant for assistance what color of connectors you should get) from your local hardware or electric supply or home improvement stores.
Minimum tools required: A fine to medium fine philips screw driver, and a pair of scissors, and a pair of mid size slip joint pliers
* For installation purpose: The length of the power strip does not include the mounting tabs (approx. 0.624"/15.8mm on both ends, if available, please check the above spec chart); the width does not include the size of screws (min. 0.064"/1.6mm on each side); the height does not include the receptacles (about 0.208"/5.3mm above the surface of the strip).
This unit is Not intended for use in or around wet or potentially wet areas including, but not limited to, aquariums, saunas, showers and fountains.
We also custom manufacture for our customers. Please contact us for more details.